Red Mustang Spray Job
This Mustang had repairs done to the rear end panel, quarter panel and a replacement bumper.The damaged area was painted white before the color coat because it helps the red cover better, known as a ground coat.
Similar Posts
Spraying Basecoat
Application of Basecoat Applying a base coat is a very commonly overlooked procedure. It requires knowledge of your paint system, proper equipment, and the painter must be able to obtain a blendable match before beginning. Your color coat is always easiest to blend when you have more room on the panel. When preparing for paint…
Fixing a Scratch
This shows a minor scrape on a Mazda Miata. The scratch was feathered out, primed and painted using BASF paint. There are many ways to get the job done, this is what was done here: 1. The scratch was feathered out using 280 grit paper until each color was separated around 1/2″. 2. Next…
Hydro Dipping: Adding Unique Patterns and Designs to Objects
Hydro dipping, also known as water transfer printing, is a process that allows you to transfer patterns and designs onto a variety of surfaces using water. It’s a popular method for adding unique and eye-catching finishes to everything from car parts and firearms to home decor and personal accessories. In this article, we’ll take a…
Spraying in a New Paint Booth!
There’s something about spraying in a modern, new paint booth that gives you an indescribable feeling. If only every booth was maintained to look like this forever it would make your life as a painter much more enjoyable. Lighting is incredible, air movement is correct, air filtration and air supply is optimal. Everything tends to…
Custom Painted Xbox Controller
The Xbox 360 Controller is an ABS plastic and gets prepared like any other plastic. The Controller is cleaned and scuffed, then washed with a plastic cleaner and sprayed with a plastic primer. It should be prepared the same way even if you chose to use an aerosol paint.This video of how to paint an…
Painting Plastic
A plastic bumper is in need of painting starting from the raw plastic. Multiple steps are required including cleaning, priming / adhesion promoter & paint.