Rob
Forum Replies Created
- Posts
Did read somewhere that if you’ve got a pressure gauge on a quick release fitment you have to add 0.2 bar to allow for the pressure drop ? (sure it was on the enclosed leaflet with the devilbiss gauge ) !
Thanks all for the advice , using gti with a 1.2 by the way , got some things to try now !
@ nick , I think ur probably right , I’m a bit old school, low ish pressure and slow passes so this proably is’nt helpin !
Any inlet pressure recommendations ?sherwin williams , about 20c , just cant seem to avoid gettin build at edges !
Thanks for your advice , no not baking them but the clear seems to bubble any way , if you are doing two doors together are you saying paint the first door extending past the edge then the second door extending past the edge ( surely this would give a lot of build at the edges ) or would’nt it be better painting 1 and a half doors then just spraying over the area thats left ?
Were theres a build up on the edge of panels , and when baked it pops and the blisters turn white when you try to polish them !