Pro Guard Rubberized Gravlguard
- This topic has 5 replies, 4 voices, and was last updated 14 years, 4 months ago by .
- Posts
I’ve used it years ago. Did you have a specific question?
I found it is ok for a cheap aerosol gravel guard. Nothing special about it. I like the 3M products a little better, especially with the special gun.
u could just get ding ta shoot yur rockers first with the clear so ya get the full benifits of a 2 2k product all the way thru the job :rofl :rofl :rofl :rofl
i like useing the 3m clear rocker guard in a spray can. but i cheat some times. i use undercoating. wait 15 mins. and then go to painting. :whistle:
I know there are better but when I applied, it forms small pin hole and it is very difficult to paint over.
I used as follows: epoxy primer on bare metal -> Gravlguard -> 2K primer -> basecoat -> Clear
try putting less on (hold the can at a greater distance). If you need more, let it flash a few minutes than go back and lightly put a little more on.
- You must be logged in to reply to this topic.