Rejean Maltais
Forum Replies Created
- Posts
I use only Presta Ultra Polish. I can use it for erase P1500 grit, blend and polish with that. I use with green foam pad and wool pad too.
I use it for Primer and basecoat. Anyway, yes i don’t have to spray upside down.
thanks for your comments
i have to paint a fence too but a small part and blend the rest.
I know there are better but when I applied, it forms small pin hole and it is very difficult to paint over.
I used as follows: epoxy primer on bare metal -> Gravlguard -> 2K primer -> basecoat -> Clear
Finally I bought the 3M PPS and I am very satisfied and the system work very well. Thank you for advice.
Hi again,
Following this problem, i’m definitely recoat. I have too much fisheye because of moisture in my line. I resolved it now.
Should i remove completly my basecoat? It does not yet seem dry when i try to sand.After new recoat
2K surface Primer -> basecoat -> Clear
thanks.
Ok thanks for hint. Maybe is moisture in my line. I see more water in my trap today. The filter just before the gun it is good for that? I have not a big system for filter and trap moisture.
Hi,
I ordered my adapter for 3M PPS, not in stock. Anyway. In PPS system 3M give all (“free”) the kit (Adapters for 2 guns, dispensers, collars etc.) with a case of 50 lids/liners.
The price is $136 CAN for 16000 on my jobber store. Same thing for small one but $101.00. It is a good price ?
Thanks.
Merci Ben
May be try 25XX on my next job.
Ok but i’m french Canadian and the specs sheet tell other thing about that (Canadian french site). Some products spec sheets are not exactly the same, i dont know why!
http://dpcprd.asp.dupont.com/dpc/fr/ca/html/prodinfo/nason/french_tds/TDS_491-16_F.pdf
Anyway, i don’t use thinner for seal if it’s not necessary.
Thanks
Ok i think try 3M.
Thanks
Ok then, what would be the best solution for my next job like?
Anyway, nope, i don’t use hardener.
Did you tell about HPC2?
Yes Focus 2005. Use 2K Nason Primer and Valpar 333 Basecoat and MS200 Clearcoat